The silent failure of the tweeter may be the open circuit of the voice coil and the disconnection in the voice coil, which is generally caused by poor product materials or man-made damage. In this situation, broadcast PA loudspeaker manufacturers should pay attention to the quality of the voice coil before production. If the lead wire is easily broken, stop using it, and check whether the voice coil wire is broken, short-circuited or open-circuited. Is there any disconnection in the place where the coil leads are drawn out? Only the quality of the voice coil can be used.
If the lead wire of the tweeter voice coil is not pressed well or the margin is not enough, it will easily cause the lead wire to be disconnected. During production, pay attention to the lead wire to be close to the diaphragm; at the same time, let the lead wire form an S line along the paper cone or on the diaphragm. The cone part makes the lead wire of the voice coil hook out a semi-circle, so that there is enough margin, the lead wire of the horn loudspeaker will not be straightened when the amplitude is on. , so it is necessary to control the welding time and let the solder fully melt. In order to ensure the firmness of the welding, it is necessary to check whether the tweeter diaphragm voice coil lead wire and insulating paint have come off, whether the lead wire is oxidized or tinned before production.
If the tweeter uses too much current, the voice coil is burned out, or the heat dissipation effect is not good, resulting in excessive heat, burning out the voice coil, or causing the paint layer to overheat and deteriorate, etc.
As a result, the tweeter is silent. In this case, you should first conduct listening and aging experiments according to the rated power of the tweeter itself, and choose the voice coil wire used.
High temperature resistant enameled wire, insulating varnish and adhesive and skeleton are also made of high temperature resistant materials. For the heat dissipation method, choose the frame with better heat dissipation, the elastic wave with good ventilation, the bottom of the basin frame, the voice coil frame, the elastic wave, the cone of the diaphragm, and the heat dissipation hole of the T iron.
To sum up, the loss of sound of the tweeter is mainly caused by various damages to the voice coil. You can refer to the reasons for maintenance and inspection during use. In addition, the broadcast speaker manufacturer also reminds everyone to pay attention to the aging of the equipment, discard it in time, and replace the tweeter with a new one to avoid the inconvenience caused by the loss of sound of the equipment.